Rebuilding of Rotating Equipment in St John’s

EMM Hardchrome & Hydraulics Ltd has more than 30 years’ experience in the rebuilding of bearing and seal fits on pump housings, pump shafts, rotors, electric motors and other rotating equipment in St John’s. Hardchrome and nickel plating is used to build up worn or damaged areas on both bores and shafts. The plating process does not cause the stresses usually associated with welding. The surface is prepared, plated and then ground to the original dimensions. The result is a low friction, extremely well wearing surface with shorter downtime, at a fraction of the replacement cost.


Contact us today for service for your rotating equipment.

Cylinder Leaking?

Avoid replacing components and have them repaired!

Created by

Legal notice